vortirr.blogg.se

1. #LINKSYS IP CAMERA VIEWER HOW TO#
2. #LINKSYS IP CAMERA VIEWER INSTALL#
3. #LINKSYS IP CAMERA VIEWER SOFTWARE#

Insert the Geovision software CD into the client PC.Geovision MultiCam Remote View Client Setup Now that the Geovision DVR (server) is set up, the Remote Viewer software needs to be installed and setup on the Client computer (the one accessing remotely over the Internet). Then click OK again on the Remote Authentication Setup screen. Create an Authorized ID and Authorized Password that you will remember.Leave the Server IP and Server Port fields set to their defaults.Click the Setup Server button on the Remote Authentication screen.Make sure that all three checkboxes are checked on the Remote Authentication Setup screen as seen below.Click on the Configure button again and select Password Setup -> Remote Authentication Setup.Under the General Settings tab and the Startup box, make sure that TCP/IP Server is checked.Click on the Configure button and select System Configure.A screenshot of the controls can be found below along with a reference of the menu that each control opens. Take note of the controls in the lower right-hand corner of the screen. If you have not already done so, please start the Geovision Multicam System that you installed from the Geovision CD. Geovision Remote View Server Setup The first part of this setup takes place on the Geovision DVR computer. D-Link port forwarding (virtual server).Please note to use port 3550 even if the instructions say something different. CCTV Camera Pros has instructions for Linksys and Dlink routers.

#LINKSYS IP CAMERA VIEWER HOW TO#

Please consult the owners manual of your router for instructions on how to setup port forwarding. 3550 is the default port that Geovision uses.

#LINKSYS IP CAMERA VIEWER INSTALL#

You can install and start the DDNS Service by following the instructions in Chapter 11, page 277 of the Geovision manual.Ĭonfigure Port Forwarding On Your Router In order to connect from the Internet or a local network to your router, your router needs to be configured to forward Internet traffic requests (TCP/IP) on port 3550 to your Geovision computer. If your Geovision computer is connected to a Dynamic IP address, start by installing the Geovision Dynamic DNS Service. If you are unsure about this, please contact your Internet provider first.

The Geovision DVR is connected to a router/switch that is connected to the Internet.The Geovision software ( Multicam Surveillance System) is already installed on the computer where your card is installed.You have already installed your Geovision DVR card into your computer.Please follow below for step-by-step setup instructions. The Remote View software gets installed on the client computer (not the Geovision DVR) that will be viewed remotely. The Remote View application is limited to only one login at a time, so multiple PCs and locations cannot connect simultaneously. Geovision Remote View System Setup The Geovision Remote View System is used to view security cameras that are connected to a Geovision system over the Internet or a network (LAN) connection.